Two Wheel Forums banner
1 - 2 of 2 Posts

· Registered
211 Posts
Discussion Starter · #1 ·
I installed a jet kit this week. My warning;when taking the "plug" out of the slide,that holds the needle in place be very careful putting it back in,on a CV Mikuni,there are four fingers that the plug sits in,the o-ring on the plug sits in a groove in the fingers,that's all,you don't need to push the plug though the floor to get it to seat!I did and now have to pay $90.00 for a new slide!!!:yikes:How could this small piece of plastic be so freaking expesive???I'm usually good with this stuff,but...In work this week I've been assembling a COMPLETE Detroit diesel series 50 and coming home to a carb with pieces so tiny,I got carried away...ninety bucks...:cursin:
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.