Idle mixture

1242 Views 2 Replies 3 Participants Last post by GSXR1000DJ, Nov 7, 2004

No Worries

Discussion Starter · Nov 7, 2004

Has anyone set the idle mixture (pilot screws) on the two inner carbs on a four cylinder? On my CBR, you can't get to the screws on the inner carbs, because the outer carbs block access. Have to take the carbs off to get to them. Has someone made a screwdriver out of cable or something?

Save

1 - 1 of 3 Posts

GSXR1000DJ

· #3 · Nov 7, 2004

I had the same question a while back when I owned my CBR and the tech tried to explain it to me and I was just like what. So I just took it in there to have it worked and fixed there. Atleast I knew it was being done right since I am not the most mechanical person when it comes to bikes. I know alot about cars but not bikes. And I'm sure its just as easy if not easier.

I know Larryg or one of the other gear heads in here will be able to answer this one for you.

Save

1 - 1 of 3 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month